Every guitarist should have all the relevant appliances that will guarantee the best sound quality. The two crucial items that you need to produce the best sound are a voltage amp and a guitar amp kit. For you to crank up your amplifier without working about the amount of sound produced, you need to have a vintage amp that has a master volume control feature. In case you have a power amplifier that lacks master volume control, you need to consider investing in an amp headphone attenuator. Attenuators are usually connected between the speaker cabinet and guitar amplifier. If you buy a modern amp, you will not have to worry about investing in an attenuator as they are in-built.
The primary function of the amp headphone attenuator is to allow you to drive your tube amplifier without causing too much noise in the neighborhood. By replicating the ohm load of your speaker, it will reduce the amount of noise produced. A wide range of attenuators in the market use a coil to lower the wattage by converting excess of it into heat. The remaining position of wattage is thereafter transferred to the speaker, hence noise reduction. Therefore, as a guitarist, if you want to enjoy playing your guitar without producing too much noise, ensure that you buy a good amp headphone attenuator.
No doubt, most guitarists find it difficult to connect their attenuators with the speaker. Start by connecting the speaker cable from the amp’s speaker output to the attenuator’s input. After that, you will need to connect the speaker cable from eth attenuator’s output to the input jack of the speaker cabinet. How is an attenuator beneficial to a guitarist? One of the crucial reasons why you need to use an attenuator is to produce absolute tone out of your amp. Also, you will not have to worry about a rise in volume even if you crank up your amp. This page provides more information on why you need to use an amp attenuator.
It is clear that an attenuator is a useful device for every guitarist, but only if you invest in the right one. Choosing the right attenuator requires one to look into certain vital aspects. First and foremost, you will have to decide on the type of attenuator you need. The two types of attenuators available in the market today are active and passive. The biggest difference between the two types is that an active attenuator requires an external power supply, while a passive attenuator does not need a power connection.
Impedance rating is an important factor to consider before buying an attenuator. Ensure that the impedance rating of your attenuator matches that of your cabinet to avoid damaging your speakers. Finally, you should check the power output rating of the attenuator. In case you desire to achieve a high volume tube tone without being too loud, you should buy an amp headphone attenuator.